About HKTDC | Media Room | Contact HKTDC | Wish List Wish List () | My HKTDC |
繁體 简体
Save As PDF Email this page Print this page
Qzone

Early Compliance Labelling Allowed for Composite Wood Products

The Environmental Protection Agency has issued a direct final rule allowing composite wood products and finished goods that contain such products that are manufactured prior to 12 December 2017 and are compliant with the formaldehyde emission standards established by Congress in 2010 (in title VI of the Toxic Substances Control Act) to be voluntarily labelled as compliant as soon as compliance can be achieved. Compliance is currently not required until 12 December but the EPA believes this rule will enhance regulatory flexibility, facilitate a smoother supply chain transition to compliance, and promote the earlier entry into commerce of lower formaldehyde-emitting products. This rule will be effective as of 25 August unless adverse comment is received by 26 July.

The EPA is also continuing to work to extend the compliance dates in its December 2016 rule implementing the formaldehyde emission standards. The EPA issued a direct final rule to this effect in May, but adverse comments were received by the deadline so the EPA is proceeding with a proposed rulemaking. The current compliance dates, along with those the EPA has proposed, are as follows.

  • Hardwood plywood (including laminated products not exempt from the definition of hardwood plywood), particleboard and medium-density fibreboard that is sold, supplied, offered for sale, manufactured or imported in the United States must be in compliance with these standards, must be certified by a third-party certifier as being in compliance, and must be labelled with the producer’s name (or other identification), lot number, third-party certifier number and a statement of compliance effective 12 December 2017 (proposed extension to 22 March 2018).
  • Finished goods made from covered products (e.g., furniture, cabinets, flooring, picture frames, toys and building materials) must be labelled with the fabricator’s name, the date the good was produced and a statement of compliance effective 12 December 2017 (proposed extension to 22 March 2018).
  • Importers of regulated composite wood products or articles that contain them must comply with the import certification regulations for chemical substances in bulk and as part of mixtures and articles in 19 CFR 12.118 through 12.127 effective 12 December 2018 (proposed extension to 22 March 2019).
  • Laminated products must comply with the hardwood plywood emission standard and the testing, certification and recordkeeping requirements for composite wood products effective 12 December 2023 (proposed extension to 22 March 2024).
  • The transitional period during which California Air Resources Board third-party certifiers may certify composite wood products under title VI without an accreditation, provided the certifier remains approved by CARB, is recognised by the EPA and complies with all aspects of the final rule, would expire 12 December 2018 (proposed extension to 22 March 2019).
Content provided by Picture: HKTDC Research
Comments (0)
Shows local time in Hong Kong (GMT+8 hours)

HKTDC welcomes your views. Please stay on topic and be respectful of other readers.
Review our Comment Policy

*Add a comment (up to 5,000 characters)